สวัสดีค่ะ ขอโทษที่รบกวนค่ะ พอดีเพื่อนเป็นคนต่างชาติแล้วเขามีคำถามเกี่ยวกับการเรียนหน่อยค่ะ
ใครทราบช่วยตอบคำถามให้หน่อยค่ะ ขอบคุณค่ะ
The design is as shown in the figure for the hinged axial compression column at both ends, the column height H=(9990mm, rounded to 50mm; the design value of bearing static load is N=(1290kN. Multi-plan design is required, and the different design plans are compared Advantages and disadvantages. The selection of materials for each program is determined by the group through negotiation. Other requirements of each program are as follows:
<img src="
https://sv1.picz.in.th/images/2020/11/05/b5hhqS.jpg" alt="b5hhqS.jpg" border="0" />
Option 1: Weld the H-shaped section as shown in the figure.
Option 2: Use hot-rolled I-shaped section.
Option 3: Hot-rolled H-section is adopted. Scheme comparison: Compare the advantages and disadvantages of each scheme and recommend the best scheme. ขอรบกวนด้วยนะคะ พอดีเพื่อนเขาไม่รู้ต้องทำยังไงแล้วค่ะ ไปเรียนก็ไม่ได้เพราะติดเรื่องโควิดค่ะ ขอบคุณค่ะ
คำถามเรื่องเรียนค่ะ Need Help วิศวกรรมโยธา
ใครทราบช่วยตอบคำถามให้หน่อยค่ะ ขอบคุณค่ะ
The design is as shown in the figure for the hinged axial compression column at both ends, the column height H=(9990mm, rounded to 50mm; the design value of bearing static load is N=(1290kN. Multi-plan design is required, and the different design plans are compared Advantages and disadvantages. The selection of materials for each program is determined by the group through negotiation. Other requirements of each program are as follows:
<img src="https://sv1.picz.in.th/images/2020/11/05/b5hhqS.jpg" alt="b5hhqS.jpg" border="0" />
Option 1: Weld the H-shaped section as shown in the figure.
Option 2: Use hot-rolled I-shaped section.
Option 3: Hot-rolled H-section is adopted. Scheme comparison: Compare the advantages and disadvantages of each scheme and recommend the best scheme. ขอรบกวนด้วยนะคะ พอดีเพื่อนเขาไม่รู้ต้องทำยังไงแล้วค่ะ ไปเรียนก็ไม่ได้เพราะติดเรื่องโควิดค่ะ ขอบคุณค่ะ